• APPLICATION

  • Clip&Rip® Universal Hidden Deck Clip FOR METAL FRAMING provides faster installation over traditional hidden clips. The 16 pre-assembled collated strips with epoxy coated 410 stainless steel screws allow for one-pass fastening, into 16 to 18 gauge steel, saving time and money on the job site.

• FEATURES

  • One-Pass Fastening: fastener can be installed in one go. The clip will remain level for sliding the next board in place
  • Compression Tabs: “crush” down onto joist, keeps clip level after screw is completely installed
  • Ease-of-Use: no additional tools needed. Installation is as easy as Insert, Drive, Snap!
  • Universal Compatibility: suitable for grooved composite, PVC, and hardwood decking
  • Time & Costs Savings: 16-clips per strip allow for installation of a full 20ft board
  • Consistent & Clean Look: clip creates 3/16″ spacing between boards

• INSTRUCTIONS

  • Before installing clips, install a PRO PLUG® SYSTEM Metal or CAP-TOR® xd Metal screw with plug at the center of every 8-foot span of deck board. (Screws and plugs sold separately.)
  • Insert the strips of clips with the arrow pointing forward into the leading board groove. Center over joist.
  • Apply consistent pressure while driving the screws down in a straight and steady fashion until the head of the screw is flush with the clip.
  • Lift up on strip to break off installed clip.
  • Install clips at every joist along length of board.
  • Place next board into position. Holding the deck board at a slight angle, push deck board into previously installed clips.
  • Check between boards to ensure consistency.

CLIP&RIP® WARRANTY

• Build with Confidence! Clip&Rip® Universal Deck Clips are warranted for use in grooved hardwood, thermally modified, PVC, and composite deck boards, including Trex®, TimberTech®, Fiberon®, MoistureShield®, Deckorators®, Armadillo® and more.
  Read full warranty